Dust Cap for stahlbus Oil Drain Valve, Alu natural

Product 3 / 6

Protection cover for Stahlbus oil drain valve

This cap is screwed onto the Stahlbus oil drain valve and protects the valve from external contamination. It still serves as a second safeguard against oil spills and is secured by an O-ring on the valve to lose.

Thread assignments for download

For a download, please click on your right mouse button and load the desired file to your PC under "Save under ...":

Thread assigment stahlbus Bleeder Valve for motorcycles ... (pdf, 46 kb)

Thread assigment stahlbus Bleeder Valve for cars ... (pdf, 33 kb)

Thread assignment stahlbus-Oil Drain Valve for motorcycles ... (pdf, 37 kb)

Thread assignment stahlbus-Oil Drain Valve for cars ... (pdf, 11 kb)

Technical data for the stahlbus Bleeder Valves for download

For a download, please click on your right mouse button and load the desired file to your PC under "Save under ...":

Technical Data (measurement) Bleeder Valves ... (pdf, 147kb)

Technical Data (measurement) Banjo bolt ... (pdf, 138kb)

Technical Data (measurement) Adapter M12x1 ... (pdf, 77kb)

Technical Data (measurement) Oil drain valve ... (pdf, 206kb)

All instruction manuals for download

For a download, please click on your right mouse button and load the desired file to your PC under "Save under ...":

How to determine the thread of the bleeding nipple ... (pdf, 24kb)

Operating instructions of the Stahlbus Bleeder Valve ... (pdf, 1.185kb)

Operating instructions for the Auxilary Refill+Bleeding Device ... (pdf, 119kb)

Operating instructions Oil dran valve ... (pdf, 442kb)

Operating instructions for Oil drain valve tool ... (pdf, 106kb)

Video

Video about the operating modes (available only in German).

Assistance for determining the thread size

In order to find the Stahlbus Bleeder Valve that fits your purposes, you first have to measure the thread of the currently installed bleeder nipple. You may either use a measuring gauge, or you may download the template prepared for this purpose.

How to measure with the measuring gauge

You determine the thread diameter by measuring the external dimensions of the thread with the slide gauge.
To determine the thread pitch, you measure the length of four thread turns with the tips of the slide gauge. Always measure the distance from thread crest to thread crest.

If the value measured is 4 mm, the thread pitch is 1.0; if the value measured is 5 mm, the thread pitch amounts to 1.25.

How to measure with the template

Take the bleeder nipple to be replaced by a Stahlbus Bleeder Valve. Compare the thread successively to the different printed pictures of threads until you have found exactly that thread which is precisely covered by the valve. Please make sure the template is even and does not wrap itself around the valve.

For valves with a diameter of M10 you have to additionally determine the thread pitch. To do so, please cut out the left corner below of the template. Then hold the thread of the valve successively above both sides of the cut-out template for the thread pitch. You have determined the correct pitch if the serrated edges of the thread template exactly match the thread turns.